How can I fix my Whirlpool Calypso washer? I keep getting the ';CL'; code and have wet laundry in the tub.

There is an error code sheet hidden in the control panel.How can I fix my Whirlpool Calypso washer? I keep getting the ';CL'; code and have wet laundry in the tub.
Here is the meaning of the CA and CL codes for your washer





CA Cl Average current limit Or Instantaneous current limit If a status signal comes back from the motor controller that a current limit has been breached, the unit will return to standby mode and display either CA for average current limit trip or Cl for instantaneous current limit trip.





Average current trip occurs if there is a 2 second average of current draw greater than 5.55 amps at the motor windings.





Instantaneous current trip occurs if there is a spike of 26 amps instantly at the motor windings.





This may signify problems with the drive motor, thermal protector, or motor controller. Over-loading the unit may cause this problem.





Here is the Link to the codes for the washer and dryer.





http://www.applianceaid.com/calypso-code鈥?/a>





Good Luck.How can I fix my Whirlpool Calypso washer? I keep getting the ';CL'; code and have wet laundry in the tub.
Sounds like your particular model has a sensor that tells you when the lid is completely latched or not. There may be something stuck between the shut off switch and the latch. Check this, if there is something there (a clump of soap or lint) clean it out and your machine should operate properly.
The control ';knob'; needs to be replaced. Thats the knob that you set for ';wash, spin, rinse';, etc. its very easy and inexpensive. just make sure you make note of what wire goes where...very easy for anybody.....oh, unplug it first!
Try this first. Adjust the 'output' hose behind the washer so it does not have a sharp bend in it. Turn washer spin cycle back on. Sometimes gravity puts a 'kink' in hose and water will not drain. Next culprit could be the 'dial ' may be to be replaced.





As for CL, each manual of different types have different codes and need to look it up in the manual or call manufacturer.
Well ~ I'm not familiar with the washer you describe but ';getting the CL code'; indicates, to me, there must be a clear button/switch to erase


the prior setting. If you can't find a ';clear'; then it may be something you shouldn't mess around with. There is an 800 number in the owner's manual - call them before you do anything (unless you are a certified repairman or have a degree in, either, mechanical engineering or computer data retrieval - joking!).